Cisco SWITCH 2.0: Inter-VLAN Routing

This course is included in our On-demand training solution.

Overview

To transport packets among VLANs, you need a Layer 3 device. This device can be either a router or a switch with Layer 3 capabilities.
Inter-VLAN routing can be performed by an external router that uses a separate link for each VLAN. Because the number of physical connections on a switch is limited, this solution is not scalable. A better solution is to have a single trunk link, between the router and the switch, that carries data for all VLANs. This setup is commonly called a router on a stick or a one-armed router.
A convenient solution is to have a device, such as a multilayer switch, that combines switching and routing functions into one device. In that case, no external router is needed.
In this course, you’ll learn how to configure an external router for inter-VLAN routing and learn the steps the configure routing on a multilayer switch.
This course offers the official training for the Implementing Cisco IP Switched Networks 2.0 certification exam which is a component exam for the CCNP and CCDP certifications. Passing this exam will also refresh CCNA certification, which expires after three years

Target Audience

This course is intended for students who are looking for real-world switching knowledge, and those that are considering CCNP and CCDP certification. This course’s discussion of switching could also benefit early CCIE Routing and Switching candidates.

Prerequisites

None

Expected Duration

90 min.

Course Objectives

Course Introduction

Inter-VLAN Routing Using an External Router

  • explain the function of inter-VLAN routing with an external router
  • Router on a Stick Operation

  • configure inter-VLAN routing with an external router and verify its operation
  • Router on a Stick Configuration

  • configure inter-VLAN routing with an external router and verify its operation
  • Inter-VLAN Routing Using an External Router: Caveats

  • describe the advantages and disadvantages of configuring inter-VLAN routing with an external router
  • Switch Virtual Interfaces Overview

  • describe the SVI
  • SVI Configuration

  • configure SVI on a switch
  • SVI Configuration Example

  • provide an example of configuring a routed port on a switch
  • SVI Autostate Exclude

  • configure SVI with the autostate exclude command
  • Switch Routed Ports Overview

  • describe the role of a routed port on a switch
  • Configuration of a Routed Interface

  • recognize the steps involved with the configuration of a routed interface
  • SVI Configuration Checklist

  • identify the checklist of SVI configuration
  • Advertising the Subnet of VLANs using EIGRP

  • use EIGRP to advertise the subnet of a VLAN
  • Configuring the EIGRP Network Statement

  • configure the EIGRP network statement
  • Switch Block Routing Example

  • provide an example of Switch Block routing
  • Layer 2 EtherChannel vs. Layer 3 EtherChannel

  • compare Layer 2 and Layer 3 EtherChannel
  • Layer 3 EtherChannel Configuration

  • configure Layer 3 EtherChannel
  • Exercise: Configuring Inter-VLAN Routing

    SUBSCRIPTION COST



     

    NEED HELP OR NOT SURE?