SENSS 1.0: NAT Deployment on Cisco IOS Software and Cisco ASA

This course is included in our On-demand training solution.

Overview

Network address translation features allows you to establish connectivity between different networks, when IP addresses between the networks are not routable or are overlapping. Connectivity is achieved by translating IP addresses in IP packets. This course provides you with an overview, configuration, verification, and troubleshooting of NAT features on Cisco ASA 5500-X Series Next-Generation Firewalls and on Cisco IOS Software routers.

Target Audience

Anyone wishing to obtain the Implementing Cisco Edge Network Security Solutions (SENSS) v1.0 certification; one of four designed for the CCNP Security track from Cisco. Knowledge of Cisco Certified Network Associate (CCNA) certification is required and knowledge of Cisco Certified Network Associate (CCNA) Security certification and Knowledge of Microsoft Windows Operating System are helpful. Note: Candidates who have a valid CCNA Routing and Switching certification AND have passed either Securing Cisco Network Devices exams 642-551 or 642-552 can act as a prerequisite valid only through December 31, 2014.

Prerequisites

Expected Duration

120 min.

Course Objectives

Course Introduction

Cisco Modular Network Architecture and NAT

  • identify the benefits of using NAT
  • Inside and Outside NAT

  • describe the benefits of using inside and outside NAT
  • Static and Dynamic NAT

  • describe static and dynamic NAT
  • NAT and NAT with PAT

  • describe NAT with PAT and policy-based NAT
  • NAT and Cisco Products and Features

  • select a Cisco product to implement NAT based on requirements
  • Overview of Cisco ASA NAT Part I

  • describe NAT configuration on Cisco ASA
  • Overview of Cisco ASA NAT Part II

  • describe the NAT table on Cisco ASA
  • Configuring Network Object NAT

  • recognize how network object NAT can be configured on the Cisco ASA
  • Configuring Static NAT using Network Object NAT Part I

  • select the tasks used to configure static NAT using Network Object NAT
  • Configuring Static NAT using Network Object NAT Part II

  • configure the traffic direction for a static NAT translation
  • Configuring Dynamic NAT using Network Object NAT

  • configure dynamic NAT using Network Object NAT on the Cisco ASA device
  • Verifying Network Object NAT

  • verify Network Object NAT on the Cisco ASA
  • Configuring Manual NAT

  • identify characteristics of Cisco ASA manual NAT configuration
  • Configuring Dynamic NAT using Manual NAT

  • configure dynamic NAT using manual NAT
  • Configuring Twice NAT using Manual NAT

  • describe the function of a twice NAT configuration
  • Troubleshooting NAT

  • troubleshoot NAT in a given scenario
  • Configuring Static NAT and PAT

  • configure static NAT on a Cisco IOS Software router
  • Configuring Dynamic NAT and PAT

  • sequence the tasks to configure dynamic NAT and PAT on a Cisco IOS Software router
  • Configuring Policy-based Dynamic NAT with PAT

  • describe how to configure policy-based dynamic NAT with PAT on Cisco IOS Software routers
  • Verifying Dynamic NAT and PAT

  • verify dynamic NAT and PAT on Cisco IOS Software routers
  • Exercise: NAT Configuration & Troubleshooting

    SUBSCRIPTION COST



     

    NEED HELP OR NOT SURE?